Remove charger and re-connect battery leads. Do not start the car - leave it for 4 hours whilst the battery control module resets itself to the new battery condition. You are now free to use the car normally. Niro 2 2017 With ADAP, Dezent spoked 16" alloys and Front Parking Sensors.
This answer was rated:โ โ โ โ โ . I have a kia ceed, 1.6 diesel,2008. When I put the key in the ignition, sometimes it is not recognised, and then - of course - the car will not start.This is an intermittent problem, but it getting more frequent. Share this conversation. Expert: Robert replied 8 years ago. I have a major problem with my Kia Ceed crdi 115hp. When starting from cold (ish)normally after standing for 4 hours or more my car misfires and emits clouds of blue smoke. This clears after a few seconds and the car performs faultlessly afterwards. The smoke smells of unburnt fuel. My average fuel consumption is 55-65 MPG and the car drivesMy diesel runs the glow plugs for about 10 seconds, and I usually hit the starter at about 7 secs. They do go off after the light goes out, so cranking the starter after that tends to just flatten the battery. So it is better to re-cycle the glow plugs - a question of understanding the vehicle.Massillon, Ohio, USA Drives. 2008 KIA Spectra, 2014 KIA Optima, 2016 Chrysler 200s, 2006 Jeep Liberty, 1997 Ford Ranger There are many causes for the engine failing to start on a cold morning. If your battery is older than 2 yrs it could be down a bit. A diesel engine needs to spin fast enough to build up enough compression. Cold weather contracts metal, piston/piston rings contract thus failing to build compression. Engine wont start - battery OK. I have a 2010 Ceed 1.6 diesel which had a clutch and crank shaft sensor replaced 3 weeks ago. Since then i have seen a deterioration in the starting behavior - i.e. long cranks before start up and then clicking noises. Thinking it was the battery I took it out and had it charged. This is a simple fix and can be done by following these steps: First, turn the Kia to the on position but do not start it. Once the dash lights come on, navigate to the service menu. From there, click "ok" to reset the system. Turn the vehicle off, and the system should be reset. .